03-09-2026, 03:55 PM
Hello
When starting the TDS software and then MSFT 2024, the normal behavior seems to be that the TDS goes into "Guage Mode" and I cannot operate in stand-alone mode.
So if my airplane choice in MSFT doesn't natively support the TDS GPS emulation in the panel (I think only a few of these are from what I can tell), is there a way to have the GPS show up at all in MSFT? Or am I forced in that case to ONLY run in stand-alone mode.
Note the only way I can get the software to run in stand-alone mode is to remove the specific directory in the Community folder.
Thoughts?
Thank you,
When starting the TDS software and then MSFT 2024, the normal behavior seems to be that the TDS goes into "Guage Mode" and I cannot operate in stand-alone mode.
So if my airplane choice in MSFT doesn't natively support the TDS GPS emulation in the panel (I think only a few of these are from what I can tell), is there a way to have the GPS show up at all in MSFT? Or am I forced in that case to ONLY run in stand-alone mode.
Note the only way I can get the software to run in stand-alone mode is to remove the specific directory in the Community folder.
Thoughts?
Thank you,