undock GTN and use on ipad

[itspilotk]

I'd like to know if I can undock the GTN with the bezel for use on a touchscreen tablet? Is there a way to not have it in Gauge mode?

---

You can disregard, I figured out how to do it, its working great thank you.

[adminOwner2]

Hello,

Thank you for letting us know, please enjoy the TDS GTNXi Pro!

[ekneos]

Hello,

I'm trying to do the same, and I know I had it working in the past, but can't get it out of Gauge mode anymore. I'm using a Pilot Experience Maule M7.

[adminOwner2]

Hello,

I'm trying to do the same, and I know I had it working in the past, but can't get it out of Gauge mode anymore. I'm using a Pilot Experience Maule M7.

Please refer to this post on enabling standalone mode:
https://www.forum.tdssim.com/thread-767.html

[itspilotk]

Hello,

I'm trying to do the same, and I know I had it working in the past, but can't get it out of Gauge mode anymore. I'm using a Pilot Experience Maule M7.


You just need to take the TDS XI folder out of the community folder

Please refer to this post on enabling standalone mode:
https://www.forum.tdssim.com/thread-767.html

---

You just need to take the TDS XI folder out of the community folder

[adminOwner2]

Hello,

I'm trying to do the same, and I know I had it working in the past, but can't get it out of Gauge mode anymore. I'm using a Pilot Experience Maule M7.


You just need to take the TDS XI folder out of the community folder

Please refer to this post on enabling standalone mode:
https://www.forum.tdssim.com/thread-767.html

---

You just need to take the TDS XI folder out of the community folder

Unfortunately we STRONGLY ADVISE AGAINST removing the "tds-gtnxi-gauge" from the MSFS Community folder. This will cause many incompatibilities and it is not necessary due to our Standalone mode.

[itspilotk]

Can you please explain then how to do this (get it into stand alone mode) without removing it from the community folder?

And I would suggest updating your posts then if you are now advising against doing this, here is one of your posts where you say to run in stand alone mode you need to remove it from the community folder:

Hello,
If you want to use stand alone mode, please remove the "tds-gtnxi-gauge" folder from the MSFS Community folder.

http://www.forum.tdssim.com/thread-615-p...ne#pid2716

[adminOwner2]

Thank you for pointing this out!

[itspilotk]

How do we get into stand alone mode?

[adminOwner2]

Please refer to the release notes, v1.0.2.5:
https://tdssim.com/forum/thread-15.html